Corn tooth zipper English name for the "Corn zipper", is in accordance with the metal zipper series tooth type double-point teeth named, by the cloth belt, microphone teeth, pull head, limit code; corn tooth tooth color is often based Need to plating up. Often used in jeans, jackets and backpacks, models generally have 3, 5, 8, 10 ... ..., its size varies according to the size of the microphone teeth.

Precautions:
1, corn tooth chain and pull the first quality of the main chain to distinguish: such as A, B, C grade, the more the better the quality of the forward level. Size to distinguish the size of the number: such as 3, 5, 8, 10 and other size, the greater the number the greater the size.
2, washing processing, should be in the corn tooth zipper closed state. Because the zipper in the open state of the washing process, there will be debris into the corn tooth head, so that self-locking pull head prone to breakage.
3, because the teeth on the corn tooth color is plating up, if not properly stored, the microphone teeth will be black and will cause pollution of the fabric. For the teeth of corn teeth are prone to oxidation, it is necessary to ensure that the preservation of ventilation, not sealed, do not save the environment is full of moisture, Dongguan Yifeng zipper factory recommended that the necessary use of moisture Paper or dehumidifier.
4, the correct method of washing: First, before washing or into the dryer, be sure to close the corn tooth zipper, the pull head fixed. If the washing is on, the front end of the top will damage the fabric and the cloth will shrink. Yifeng zipper factory prompted the second is a strong alkaline detergent or chlorine bleach will be applied to the zipper wax or oil film melted off, use, please pay special attention.

Maintenance:
    The reason is not smooth: First, the teeth of corn teeth rust or contaminated with dirt. Faced with this situation, just use wax in the zipper gently rub on both sides, you can smooth smooth;
     Second, the corn tooth zipper logic head caught in the cloth edge and the like. The solution to this situation is generally: should be slowly returned to the original key, to body foreign body. Zipper is not close monitor, because the use of a long time, the head of the upper and lower pieces of Pieces of Jiang big or for a distance. Yifeng zipper Tips: just use the pliers up and down or about the clip on the line, but be careful not to force too much, so as not to clip bad corn tooth zipper.

Repair method:
    1, corn tooth zipper "tooth" or "skew" and so on, can remove the bad teeth, add new teeth, can still be used; when the corn tooth zipper pull the first, the two sides do not close, this shows zipper wear Hair loose, can be used ordinary pliers in the corn tooth zipper head side of the closed side of the light gently clamp, then immediately changed for the better, both sides of the teeth together tight, no longer loose.
    2, if the corn teeth zipper is not smooth, with candles or wax coated on the top, can improve the results. If a little anti-nitroglycerin can be used to complement the skin color cream or white light oil ethane lightly wipe the site of denitrification, remove the stains above.
    3, if the corn tooth zipper light slip or pull the fixed phenomenon, the general reason is that its specifications caused by too large and pull the specifications of the head does not match, this situation need to adjust the zipper with the re-match.
    4, when the switch zipper in corn, and sometimes pull the first clip to the folder leaving the corn tooth zipper can not move. At this point if the blindly strong pull, only to Bukata tighter, therefore, Dongguan Yifeng zipper factory as far as possible to pull the card in the pull of the cloth pull and pull back to the original position, if the full card Dead, do not be too hard, as long as you can slowly pull. In addition, the sewing of corn teeth zipper should also pay attention to the formation of sewing.